That's more options indeed
I would first try with this:
PS: do the 2 devices appear when you are booting up the pc ? (first boot devkit, wait for 10 secs, then boot pc)
Normally, after the message of the SCSI bios ("press CTRL+A for SCSI card bios), it should wait a little bit, then show the SCSI devices it detected (normally, the DA & GD-M)
I would first try with this:
- sync transfer rate for id 3 & 4: I would put 10 or so, there's no point in going higher, I don't think the devkit can handle that.
- initiate wide negotation: I would put 'no' for id 4
- send start unit: try with 'no' for id 3 & 4
PS: do the 2 devices appear when you are booting up the pc ? (first boot devkit, wait for 10 secs, then boot pc)
Normally, after the message of the SCSI bios ("press CTRL+A for SCSI card bios), it should wait a little bit, then show the SCSI devices it detected (normally, the DA & GD-M)