Welcome, Guest!

Here are some links you may find helpful

Mayumi v4 pu-18 stealth issue

takeshi385

Active member
Original poster
Registered
Jun 4, 2019
26
6
3
I’ve been installing mayumi v4 mod chips for years mostly on psones and pu-20 motherboards, but recently installed it on a pu-18 motherboard. For some reason no matter the mode dino crisis can sense the chip. Is this normal?
 

takeshi385

Active member
Original poster
Registered
Jun 4, 2019
26
6
3
I couldn't figure out the issue, but was informed that it could be an issue with the chip(12f629) it was burned to.
 

Vorde

Member
Nov 18, 2019
21
8
3
I couldn't figure out the issue, but was informed that it could be an issue with the chip(12f629) it was burned to.
I would try burning the Hex to a 12C508 or a 12F508 and see if the stealth code works with it. I ran into a forum post somewhere the other day saying that stealth only works on some chips with certain models.
 
  • Like
Reactions: takeshi385

Mord.Fustang

Well-known member
Jun 17, 2019
50
28
18
Not sure what the issue is as I've tested the 12F629 port of Mayumi v4 on a PU-18 board before. Mine was an NTSC-U model. What model is the PS1?

Couldn't hurt to try the original code.
 
Last edited: