N64 [N64] Is this RGB mod already set for component out?

[dannygranger]

Bought this on eBay and it's RGB modded, but seller couldn't confirm if it could also do component if I get a cable. Anyone check the pic and tell me if there's anything that needs changed to enable component?

 

[deadlegion]

N64 Advanced borti4938
If that is setup for RGB atm then I think you can change to component output via OSD.

If you look at the picture you posted, to the right you see the R/Pr, Gs/Y, B/Pb pads... above that is red wire soldered to CS 75Ω.

For sync, it's recommended to use the 75Ω output wired to either Luma or CSync.

OSD settings (shamelessly stolen from elsewhere) see attached picture...

 

[dannygranger]

I'm hoping so, but the only other person I seen with the board was a french guy fitting one on YouTube and he couldn't get a component signal even though he had RGB working fine via SCART...

Another guy on YT said I had to solder jumpers?

 

[deadlegion]

Originally these boards had jumpers to enable some stuff but from what I understand all of that became redundant since firmware updates.
I don't have a setup with this myself at the moment.

I have the installation PDF if you want that? It has references to the jumpers and stuff.

Edit:
For the French guy on YT maybe he didn't build the right component cable?

The PDF isn't hard to find.