Hi,
In an attempt to dump my collection of NR discs, I acquired an internal Panasonic SW-9501 and am currently trying to use it on my PC.
However when I boot in normal mode, I face a Windows black screen of death, with a white cursor.
Also, the DVD drive is always making a noise, as if the lens was trying to read something, somewhat similar to when a Gamecube fails reading a disc and raises an error.
The following pictures is what I see in Windows Safe boot mode.
I have a jumper for SCSI ID = 2 (My adaptec card is ID = 7)
I also have a jumper for termination.
No humper for Parity.
Also, do I need to cut the SCSI cable between PCI card and Drive so that there is no unused ports on the cable ?
In an attempt to dump my collection of NR discs, I acquired an internal Panasonic SW-9501 and am currently trying to use it on my PC.
However when I boot in normal mode, I face a Windows black screen of death, with a white cursor.
Also, the DVD drive is always making a noise, as if the lens was trying to read something, somewhat similar to when a Gamecube fails reading a disc and raises an error.
The following pictures is what I see in Windows Safe boot mode.
- Windows Device Manager sees the drive :
- NR writer patch seems to works :
- NR writer program sees ths drive (note that it sometimes lags for ~1 minute when the drive makes the noise described earlier)
- However Rawdump raises an error (Please note that it is written "GameCube disc detected" whereas the drive was empty)
- This is my setup.
Is it correct ?
I have a jumper for SCSI ID = 2 (My adaptec card is ID = 7)
I also have a jumper for termination.
No humper for Parity.
Also, do I need to cut the SCSI cable between PCI card and Drive so that there is no unused ports on the cable ?
- Finally, I don't know if this is normal behaviour but my Adaptec PCI card BIOS says my SW-9501 is not a Disk Drive ?
- Additional details : running all of this on Windows 10 - 64 bits.
Adaptec PCI cards drivers do not work on 64 bits, so I used these ones
Last edited: