THS7374 - Schematic help

[Esplanade]

Im currently trying to get back into the scene and I thought I would try and get my head around making pcbs for myself for some projects of mine, nothing exciting or new but i was just wondering if i can get some input from you guys.

• I just realised after uploading the image that i dont have the components on the csync out line.
• Are the jumpers set right to be able to turn the filter on/off?
• I realise that the components on the output side are usually left out because theyre inlcuded in most cables but this is intentional
• Am I missing anything else important?

 

[bond.san]

GitHub - borti4938/SNES_RGB_Bypass

Contribute to borti4938/SNES_RGB_Bypass development by creating an account on GitHub.

github.com

Internal filter bypass. Logic high bypasses the internal low-pass filter; logic low uses the internal filters.
This pin must not be left floating. It must be connected to a defined logic state (or GND or VS+).


not sure but input pull-up or pull-down resistors need adjusting according to the the source circuit RGB voltages
as to prevent clipping of input signal ( maybe also output ).

In my scart cable i have added parallel 0.1uF caps as recommended in the 7374 datasheet.